Micro 7.62×39 AR15 pistol w/folding stock

Description

It’ll make an amazing truck gun or bag gun

I enjoy putting these together as a hobby these days (I’m a trained gunsmith)and making it awesome and super reliable. I have personally gauged all the holes and critical spec (based on SOTAR and mil spec TDP numbers) on this and done a level two armory inspection, correcting or replacing any out of spec parts. Then I test shoot it in semi and binary and make adjustments as needed so it is stone reliable. Here are the specs

Phase 5 pigtail gas tube. Increases dwell time to smooth recoil and enhance cycling reliability.

Spikes tactical barking spider muzzle brake. Helps increase back pressure on short barrels for better dwell time and eliminates muzzle blast and flash making this pleasant to shoot without deafening the guy next to you.

7075 T6 receiver, upper and buffer tube. Tough and ready for this caliber!!

Flat wound recoil spring. Smooths out the spring pressure over the entire recoil cycle to make recoil impulse smoother and feeding more reliable by maintaining a more consistent spring pressure thru the cycle. Eliminates spring sproing noise.

Headspaced bolt and barrel

Polished feed ramps and chamber for reliable feeding with steel case and soft point ammo.

Checked barrel and gas port with bore scope and cleaned properly

Barrel bedded and torqued to spec for superior accuracy

Adjustable gas block

Adjustable Brace included

Folding stock adaptor

Franklin binary trigger. This caliber is nicer in binary than supersafe

Trigger job set to 5.5lbs for reliable duty use

New Duramag magazine.

Report problem